BEON No-Drill Suction Hooks: Installation & Removal Guide

Watch the short video below before installing or repositioning your BEON No-Drill Suction Hooks.

Before you install

1. Choose a completely smooth, flat and non-porous surface.
2. Clean the surface thoroughly and let it dry completely.
3. Loosen the cap, press the suction base firmly against the surface, then twist until firmly locked.
4. Check that the hook is secure before adding weight.

For best results: Keep the load within 10 lb / 5 kg per hook. Actual holding performance depends on surface compatibility and correct installation.

Need help with your surface?

Reply to your BEON email with a clear photo of the surface and tell us what you plan to hang. Our team will help you check whether it is suitable.

Important: Avoid ordinary drywall, plaster, textured walls, brick, concrete, unsealed wood and other rough or porous surfaces. Tiny air gaps can weaken the vacuum seal over time.